Installation is an easy process. Click on each of the following eight steps to install your Spaloo:
  Do not plug the system in before completing the installation
1 Loosen the nuts on the mounting bolts and remove the toilet seat assembly currently in place on your toilet. (Click here to view)
2

Place the two bolts into base B, then push through the packing and toilet bowl. Tighten nuts and rubber washers to secure bolt. (Click here to view)
3

Align Spaloo toilet seat with the mounting plate. Push the Spaloo seat system into base following the arrow. Within securing, a click will sound.

Depress button and hold down as you slide Spaloo toilet seat on or off mounting plate. (To uninstall: push the slide plate button and pull out the unit.)

It is important to press and hold down the side button as you slide toilet seat on and off so it does not damage the "clamps" on the underside of the toilet seat upon installation.

You may want to push button in and out before sliding toilet seat onto mounting plate and view underneath carriage so that you can see the "clamps" or "teeth" operate before installing for the first time. (Click here to view)
4 Shut off water supply valve (located at the bottom of the wall) and flush the toilet to empty water tanks. Remove the water hose from the bottom of the water tank (ball cock). (Click here to view)
5 Attach the T-connector (provided) to the bottom of the water tank. (Click here to view)
6 Connect the water hose to the T-. connector (7/8" threaded side). (Click here to view)
7 Connect flexible water hose (provided) from T-connector (1/2" threaded side) to Spaloo system external water tank located under control panel. (Click here to view)
8 Turn the water on. Check for leaks. If no leaks, plug unit in to wall, which turns unit “On.”
   
  Please call if you do not understand the Installation procedures: Spaloo Customer Support: 1-800-275-0798